Comments on: Fujita Launches Intake for 2007 350Z!

By: Dan

Dan — Tue, 04 Sep 2007 12:22:51 +0000

Seems about right to me. There are two runs shown on the dyno sheet, a baseline/stock and then after the modification. The first run shows 255rwhp which using a 15% drive train loss puts you at 300 engine hp. The second run show about 262rwhp (estimate) which using the same loss factor, equals 308 engine hp. Keep in mind I'm assuming this is a manual trans car.

By: Mike R

Mike R — Thu, 07 Jun 2007 21:26:20 +0000

Joshua, all manufactures lie about the HP because out of the factory it is calculated from the crank not the rear wheels. As for the Pontiac Grand Prix – K&N makes a intake for that model.

By: Joshua A.

Joshua A. — Wed, 06 Jun 2007 21:48:31 +0000

Either that intake is taking a lot of power away from the car or the factory lied about the HP because the dyno shows it is only making 255 HP. Perhaps if it is an automatic I could understand it, but not if it's a manual (15% drivetrain loss for a manual).

Also, Datoor is a joke. "Universal" intakes? Give me a break.

By: FAT DADDY RACING

FAT DADDY RACING — Wed, 06 Jun 2007 13:30:13 +0000

Got one that will work on a Pontiac Grand Prix GTP 05 model?

By: Jason

Jason — Wed, 06 Jun 2007 12:22:41 +0000

Yea to bad that the Datoor intake wont work on the 2007 350z, due to the "dual intakes" Riz

By: Riz

Riz — Wed, 06 Jun 2007 08:51:59 +0000

I think the DATOOR intakes suit the 350′s much better.
http://www.DATOOR.com